DS-15 Typhoon MD Hbar
Available Finishes: Black Anodized, Flat Dark Earth H Series Cerakote, Copperhead Brown H Series Cerakote, or Olive Drab Green H Series Cerakote
Every firearm is hand‑assembled and individually tested at our factory in Rockledge, Florida, with all American‑made components and materials.
LIFETIME WARRANTY – Fully Transferable, No Registration or Proof of Purchase Required
TECHNICAL SPECIFICATIONS
| Precision Matched Receiver Set | • Machined from US‑produced 7075 T651 aluminum • Mil‑Spec Type III Class 2 hardcoat anodized finish |
| Billet Lower Receiver | • Threaded bolt catch screw • M4 cut low‑rear‑shelf trigger pocket • Extended takedown & pivot pins |
| Billet Upper Receiver | • Mil‑Spec pinned forward assist • Threaded forward assist screw • Mil‑Spec dry film lubricated bore |
| Partial Ambidextrous Controls | • DSI Atach™ ambi charging handle • DSI billet ambi 90° safety selector • Mil‑Spec investment‑cast bolt catch • Premium investment‑cast single‑stage trigger (4.5 lb. pull) |
| DSI Mil+ Bolt Carrier Group | • 8620 bolt carrier (diamond‑honed bore) • 9310 bolt (enhanced profile) • 4130 gas key (Grade 8+ Torx‑staked) • 8740 steel ground chrome firing pin • Springco XP 5‑coil extractor spring |
| DSI 16″ HBAR Profile Barrel |
• 4150 CMV steel (MIL‑B‑11595E) |
| DSI Mil+ Carbine Buffer System | • Neoprene‑dampened buffer with bump‑stop • Electropolished 17‑7 stainless spring • 7075 buffer tube (6‑position, drain/vent holes) • Dry film lubricant in tube bore • Dual‑staked QD end plate & castle nut |
| Included Accessories | • 10‑round polymer magazine • Keyed cable lock |
Specifications subject to change without notice.
