DS-15 Typhoon Standard Rifle 16″
Built on a precision‑matched billet receiver set, the DS‑15 Typhoon is a workhorse rifle ideal for sport shooting, home defense, hunting, or patrol. It features partial ambidextrous controls and an extended 13″ M‑Lok handguard ready for optics and attachments. The SOCOM‑profile 16″ barrel delivers long‑range accuracy without extra bulk. Up front, a Firestorm compensator cuts muzzle rise and felt recoil. A Hogue rubber over‑molded polymer pistol grip offers rock‑solid control in any condition.
Available Finishes: Black, Flat Dark Earth, Copperhead Brown, Olive Drab Green
- NOTE: Due to the anodizing process, color tints may vary.
Every firearm is hand‑assembled and individually tested at our factory in Rockledge, Florida, with all American‑made components and materials.
LIFETIME WARRANTY – Fully Transferable, No Registration or Proof of Purchase Required
TECHNICAL SPECIFICATIONS
| Precision Matched Receiver Set | • Machined from US‑produced 7075 T651 aluminum • Mil‑Spec Type III Class 2 hardcoat anodized finish |
| Billet Lower Receiver | • Threaded bolt catch screw • M4 cut low‑rear‑shelf trigger pocket • Extended takedown & pivot pins |
| Billet Upper Receiver | • Mil‑Spec pinned forward assist • Threaded forward assist screw • Mil‑Spec dry film lubricated bore |
| Partial Ambidextrous Controls | • DSI Chinook ambi charging handle • DSI billet ambi 90° safety selector • Mil‑Spec investment‑cast bolt catch • Premium investment‑cast single‑stage trigger (6–7 lb pull) |
| DSI Mil+ Bolt Carrier Group | • 8620 bolt carrier (diamond‑honed bore) • 9310 bolt (enhanced profile) • 4130 gas key (Grade 8+ Torx‑staked) • 8740 steel ground chrome firing pin • Springco XP 5‑coil extractor spring |
| DSI 16″ SOCOM Profile Barrel | • 4150 CMV steel (MIL‑B‑11595E) • Button‑rifled; twist options: 1:7 or 1:9 (1:8 .300 Blk) • Carbine or mid‑length gas system • Black nitride heat‑treat finish |
| DSI Mil+ Carbine Buffer System | • Neoprene‑dampened buffer with bump‑stop • Electropolished 17‑7 stainless spring • 7075 buffer tube (6‑position, drain/vent holes) • Dry film lubricant in tube bore • Dual‑staked QD end plate & castle nut |
| Included Accessories | • 30‑round polymer magazine • Keyed cable lock |
