DS-15 Typhoon Fixed Magazine Rifle
The DS-15 Typhoon Fixed Magazine Rifle is built for compliance in many states with "assault weapon" bans, including Connecticut, Illinois, Maryland, New Jersey, New York (varies by County), Washington DC, and Washington State. With a permanently affixed magazine and patented fixed mag lower receiver, it does not meet the definition of an "assault weapon" in these jurisdictions.
Built on our precision matched patented fixed magazine billet receiver set, the DS-15 Typhoon is a workhorse rifle suited for sport shooting, home defense, or hunting. It features partial ambidextrous controls and a 13" M-Lok handguard for accessory mounting. The SOCOM-profile 16" barrel delivers long-range accuracy while remaining lightweight and compact. A Firestorm compensator on the front end helps reduce muzzle rise and felt recoil. Hogue rubber over-molded pistol grip ensures control in all conditions.
Available Finishes: Black Anodized, Flat Dark Earth H Series Cerakote, Copperhead Brown H Series Cerakote, or Olive Drab Green H Series Cerakote
Every firearm is hand‑assembled and individually tested at our factory in Rockledge, Florida, with all American‑made components and materials.
LIFETIME WARRANTY – Fully Transferable, No Registration or Proof of Purchase Required
TECHNICAL SPECIFICATIONS
| Precision Matched Receiver Set | • Machined from US‑produced 7075 T651 aluminum • Mil‑Spec Type III Class 2 hardcoat anodized finish |
| Billet Fixed Magazine Lower Receiver | • Threaded bolt catch screw • M4 cut low‑rear‑shelf trigger pocket • Extended takedown & pivot pins |
| Billet Upper Receiver | • Mil‑Spec pinned forward assist • Threaded forward assist screw • Mil‑Spec dry film lubricated bore |
| Partial Ambidextrous Controls | • DSI Atach™ ambi charging handle • DSI billet ambi 90° safety selector • Mil‑Spec investment‑cast bolt catch • Premium investment‑cast single‑stage trigger (4.5 lb. pull) |
| DSI Mil+ Bolt Carrier Group | • 8620 bolt carrier (diamond‑honed bore) • 9310 bolt (enhanced profile) • 4130 gas key (Grade 8+ Torx‑staked) • 8740 steel ground chrome firing pin • Springco XP 5‑coil extractor spring |
| DSI 16″ or 14.5" SOCOM Profile Barrel | • 4150 CMV steel (MIL‑B‑11595E) • Button‑rifled; twist options: 1:7 or 1:9 (1:8 .300 Blk) • Carbine or mid‑length gas system • Black nitride heat‑treat finish |
| DSI Mil+ Carbine Buffer System | • Neoprene‑dampened buffer with bump‑stop • Electropolished 17‑7 stainless spring • 7075 buffer tube (6‑position, drain/vent holes) • Dry film lubricant in tube bore • Dual‑staked QD end plate & castle nut |
| Included Accessories | • 10‑round polymer magazine • Keyed cable lock |
Specifications subject to change without notice
