DS-15 M4 MD HBAR Rifle
Description
DS-15 M4 Maryland HBAR Rifle
Built on a precision-matched forged receiver set, the DS-15 M4 is a throwback to the original M4 ideal for sport shooting, home defense, hunting, or patrol. It features standard controls and M4 furniture, F height A2 front site post and a period correct carry handle. The HBAR-profile 16″ barrel delivers long-range accuracy without extra bulk as well as Maryland compliance. Up front, an A2 birdcage cuts muzzle flash and some felt recoil.
Available Finishes: Black Anodized
Every firearm is hand-assembled and individually tested at our factory in Rockledge, Florida, with all American-made components and materials.
LIFETIME WARRANTY – Fully Transferable, No Registration or Proof of Purchase Required
TECHNICAL SPECIFICATIONS
| Forged Lower Receiver | • M4 cut low-rear-shelf trigger pocket • Extended takedown & pivot pins |
| Forged Upper Receiver | • Mil-Spec pinned forward assist • Mil-Spec dry film lubricated bore |
| Standard Controls | • DSI standard charging handle • DSI standard 90° safety selector • Mil-Spec investment-cast bolt catch • Premium investment-cast single-stage trigger (4.5 lb. pull) |
| DSI Mil+ Bolt Carrier Group | • 8620 bolt carrier (diamond-honed bore) • 9310 bolt (enhanced profile) • 4130 gas key (Grade 8+ Torx-staked) • 8740 steel ground chrome firing pin • Springco XP 5-coil extractor spring |
| DSI 16″ HBAR Profile Barrel | • 4150 CMV steel (MIL-B-11595E) • Button-rifled; twist options: 1:9 • Carbine gas system • Black nitride heat-treat finish |
| DSI Mil+ Carbine Buffer System | • Neoprene-dampened buffer with bump-stop • Electropolished 17-7 stainless spring • 7075 buffer tube (6-position, drain/vent holes) • Dry film lubricant in tube bore • Dual-staked QD end plate & castle nut |
| Included Accessories | • 10-round polymer magazine • Keyed cable lock |
Specifications subject to change without notice.