DS-15 Typhoon MD HBAR Rifle
496377047531
Description
DS-15 Typhoon MD Hbar
Effective 03/01/2026: Black, ODG and CHB rifles will ship with a Magpul DT Stock and K2 pistol grip. FDE will continue to ship with a Hogue overmolded furniture until stock is depleted.
Available Finishes: Black Anodized, Flat Dark Earth H Series Cerakote, Copperhead Brown H Series Cerakote, or Olive Drab Green H Series Cerakote
Every firearm is hand-assembled and individually tested at our factory in Rockledge, Florida, with all American-made components and materials.
LIFETIME WARRANTY – Fully Transferable, No Registration or Proof of Purchase Required
TECHNICAL SPECIFICATIONS
| Precision Matched Receiver Set | • Machined from US-produced 7075 T651 aluminum • Mil-Spec Type III Class 2 hardcoat anodized finish |
| Billet Lower Receiver | • Threaded bolt catch screw • M4 cut low-rear-shelf trigger pocket • Extended takedown & pivot pins |
| Billet Upper Receiver | • Mil-Spec pinned forward assist • Threaded forward assist screw • Mil-Spec dry film lubricated bore |
| Partial Ambidextrous Controls | • DSI Atach™ ambi charging handle • DSI billet ambi 90° safety selector • Mil-Spec investment-cast bolt catch • Premium investment-cast single-stage trigger (4.5 lb. pull) |
| DSI Mil+ Bolt Carrier Group | • 8620 bolt carrier (diamond-honed bore) • 9310 bolt (enhanced profile) • 4130 gas key (Grade 8+ Torx-staked) • 8740 steel ground chrome firing pin • Springco XP 5-coil extractor spring |
| DSI 16″ HBAR Profile Barrel | • 4150 CMV steel (MIL-B-11595E) • Button-rifled; 1:9 Twist • Carbine or mid-length gas system • Black nitride heat-treat finish |
| DSI Mil+ Carbine Buffer System | • Neoprene-dampened buffer with bump-stop • Electropolished 17-7 stainless spring • 7075 buffer tube (6-position, drain/vent holes) • Dry film lubricant in tube bore • Dual-staked QD end plate & castle nut |
| Included Accessories | • 10-round polymer magazine • Keyed cable lock |
Specifications subject to change without notice.