DS-15 M4 Commando Non-NFA Firearm
Description
DS-15 M4 Commando Non-NFA
Born out of a collaboration with SC Arms NJ, the Dark Storm DS-15 M4 Commando Non-NFA is a retro-inspired firearm built around the classic M4 configuration. It features an F-height A2 front sight post, carry handle, flat trigger guard, extended forward assist, M4 furniture, M4 pistol grip, Harrington & Richardson M4-style brace, broom-handle vertical foregrip, and a 10.5-inch barrel with a pinned and welded A2 flash hider. This configuration makes the M4 Commando the shortest Non-NFA firearm currently offered by DSI.
Every firearm is hand-assembled and individually tested at our factory in Rockledge, Florida, using American-made components and materials.
LIFETIME WARRANTY – Fully Transferable, No Registration or Proof of Purchase Required
Technical Specifications
| Precision Matched Receiver Set |
• Machined from US-produced 7075 T651 aluminum • Mil-Spec Type III Class 2 hardcoat anodized finish |
| Forged Lower Receiver |
• M4-cut low-rear-shelf trigger pocket • Extended takedown and pivot pins |
| Forged Upper Receiver |
• Mil-Spec pinned extended forward assist • Mil-Spec dry-film lubricant applied to bore |
| Controls |
• DSI standard charging handle • DSI 90° safety selector • Mil-Spec investment-cast bolt catch • Mil-Spec investment-cast single-stage trigger with 4.5 lb. pull |
| DSI Mil+ Bolt Carrier Group |
• 8620 bolt carrier with diamond-honed bore • 9310 enhanced-profile bolt • 4130 gas key with properly staked Grade 8+ Torx Plus hardware • 8740 steel ground chrome-plated firing pin • Carburized to Mil-Spec hardness • Mil-Spec manganese-phosphate and hard-chrome finish • Sprinco XP 5-coil extractor spring |
| DSI 10.5″ SOCOM-Profile Barrel with Pinned & Welded A2 Flash Hider |
• Premium 4150 CMV steel certified to MIL-B-11595E • Button-rifled with 1:7 twist • Carbine-length gas system • Black nitride heat-treatment finish |
| DSI Mil+ Carbine Buffer System |
• Neoprene-dampened buffer with high-durometer bump stop • Electropolished 17-7 stainless steel buffer spring • 7075 six-position buffer tube with drain and vent holes • Mil-Spec dry-film lubricant in buffer tube bore • Dual-staked QD socket end plate and castle nut |
| Included Accessories |
• 10/20 USGI steel magazine or 30-round PMAG, depending on state law • Keyed cable lock |
Legal Notice
The DS-15 M4 Commando is configured and offered by DSI as a Non-NFA firearm for jurisdictions where this configuration is permitted, including New Jersey, Virginia, and Delaware under DSI's current compliance determination.
DSI does not currently offer this configuration for sale in Massachusetts, Maryland, California, New York, Connecticut, Illinois, Washington State, or Washington, D.C.
DSI's Non-NFA classification is based on the firearm's intended configuration, including the absence of a shoulder stock, the use of a vertical forward grip for two-handed operation, and an overall length greater than 26 inches.
State and local firearm laws can change, and customers and transferring dealers should confirm that the configuration is permitted in their jurisdiction before purchase or transfer.
Proudly made in the USA
Specifications subject to change without notice.